Configure working periods, pause intervals, weekdays and aroma concentration for the scenting program.
Press the [MODE] key for the first time. The LCD display shows the factory-set time, and the machine can set up to two working time periods.
For example: 08:00–10:00, 11:00–12:00 and 13:00–14:00. If the working period crosses midnight, set two periods: the first period 08:00–23:59 and the second period 00:01–06:00.
Press the [SET] key to enter the working clock setting for the first period. The hour start value will flash. Press [UP/DOWN] to adjust the start hour.
Press [SET] a second time to confirm the hour. The minute start value will flash. Press [UP/DOWN] to adjust the start minutes.
Press [SET] a third time to confirm the start time. The weekday selection will flash. Press [UP] to select a working weekday. Press [UP] again to deselect it. Use [DOWN] to continue setting other weekday combinations.
Press the [MODE] key for the second time. The LCD display will show [EVENT 1 OFF], indicating the pause time for the first group.
Press [SET] to enter the program setting, then press [UP/DOWN] to adjust the hours and minutes.
Press the [MODE] key for the third time to set the device density. Press [UP/DOWN] to adjust the density.
Select the appropriate density. Each adjustment changes by 5 seconds. The maximum value is 300 seconds and the minimum value is 5 seconds.
1. When the running time is set, the shutdown time cannot precede the startup time;
2. If the running time period needs to exceed 00:00, it needs to be set separately in two time periods
3. The WIFI signal indicator will keep flashing when it is not equipped with a network, and it will stop flashing after it is equipped with a network (the same AP mode)
ตะกร้าสินค้าของคุณว่างเปล่าในขณะนี้
เริ่มช้อปปิ้ง